Filter
Top Products
125
When the camera is properly connected to the computer, a drive icon will appear. If the
computer does not recognise the camera, disconnect the camera and restart the com-
puter. Repeat the connection procedure above.
After using the four-way keys of the controller to high-
light the USB option in the USB section of the data-
transfer menu, press the the right key of the controller.
• “Enter” should appear on the right side of the screen.
Press the centre of the controller to send a signal to
the computer to initiate the USB connection.
• A screen will appear to indicate the beginning of the
connection process.
• When the signal has been received by the computer, the
camera’s
monitors will turn off.
6
7
Trans
USB
USB
Enter
Initialising USB
connection