Filter
Top Products
87
DATA IMPRINTING
Data can be printed directly on the image. The imprinting function must be activated
before the image is taken. Once activated, data will continue to be imprinted until the
function is reset; a yellow bar is displayed behind the distance indicator and frame
counter on the monitors to indicate the imprinting function is active. Data imprinting is
controlled in the Custom 2 section of the recording-mode menu (p. 80).
No
YYYY/MM/DD
MM/DD/hr:min
Text
Text + ID#
Recording-mode
menu setting
Data imprinting function disabled.
Prints the year, month, and day the image was taken.The date format can
be changed in the Custom 2 section of the setup menu (p. 114).
Prints the date and time the image was taken. The date and time can be
set in the Custom 2 section of the setup menu (p. 114).
Up to 16 characters can be printed on the image. When this setting is
selected, the electronic keyboard will appear (p. 88).
Up to eight characters and a serial number can be printed on the image.
As each successive image is captured, the ID number will increase by
one. When this setting is selected, the electronic keyboard will appear (p.
88). The serial number is reset every time the setting is made.
The data is imprinted in the lower right corner of the image when viewed horizontally.
Only one imprinting format can be employed at one time. The data is printed directly on
the photograph, writing over the image information.
Every time a still image is recorded, it is stored with an Exif tag that contains the date and time
of recording as well as shooting information. This information can be viewed with the camera in
the playback or quick-view mode or on a computer with the DiMAGE Image Viewer Utility soft-
ware .
Camera Notes