Nikon 25468 Digital Camera User Manual


 
144
l
Flash Mode
The flash modes available vary with shooting mode:
To choose a flash mode, press the M button and rotate
the main command dial until the desired setting is
displayed in the control panel.
i, k, p, n, s, w o 0
Auto
Auto+slow sync+
red-eye reduction
Fill flash
Auto+red-eye reduction Auto+slow sync
j Off j Off
P, A S, M
Fill flash Fill flash
Red-eye reduction Red-eye reduction
Slow sync+red-eye reduction Rear-curtain sync
Slow sync
Rear curtain+slow sync
*
* S is displayed when setting is complete.
D The Built-in Flash
Use with lenses with focal lengths of 16–300 mm (0 271).
Remove lens hoods to prevent shadows.
The flash has a
minimum range of 0.6 m (2 ft.) and can not be used in the
macro range of macro zoom lenses.
i-TTL flash control
can be used at ISO sensitivities between 100 and 6400.
At
values over 6400, the desired results may not be achieved
at some ranges or aperture settings.
If the flash fires in continuous release mode (0 78), only
one picture will be taken each time the shutter-release
button is pressed.
The shutter release may be briefly disabled to protect the
flash after it has been used for several consecutive shots.
The flash can be used again after a short pause.
M button Main command dia
l
Control panel