Nikon COOLPIX5900 Digital Camera User Manual


 
139
Technical Notes
Cleaning
Lens/Viewfinder
One key to cleaning the lens is to not touch it with your fingers. Remove dust
or lint with a blower (typically a small device with a rubber bulb attached to
one end that you pump to produce a stream of air out the other). To remove
fingerprints or other stains that can not be removed with a blower, wipe the
lens with a soft cloth, using a spiral motion that starts in the center of the lens
and works out to the edges.
Monitor
Remove dust or lint with a blower. To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Avoid contact with liquid crystal
Should the monitor break, care should be taken to avoid injury due to broken glass and
to prevent the liquid crystal from the monitor touching the skin or entering the eyes or
mouth.
Body
Use a blower to remove dust, dirt or sand then wipe gently with a soft, dry
cloth. After using the camera at the beach or seaside, wipe off any sand or
salt with a dry cloth lightly dampened with fresh water, then dry thoroughly.
The camera may be damaged if foreign matter gets inside the camera body.
Nikon cannot accept liability for damage caused by dirt or sand.
Do not use alcohol, thinner, or other volatile chemicals.
Notes on the Monitor
The monitor may contain a few pixels that are always lit or that do not light. This is a character-
istic common to all TFT LCD monitors, and does not indicate a malfunction. Images recorded us-
ing the product will not be affected.
When you frame bright subjects, vertical comet-like streaks that whiten toward either end may
appear in the monitor. This phenomenon, known as “smear,” does not appear in the final pho-
tograph and does not indicate a malfunction. Some smear may appear in movies.
Images in the monitor may be difficult to see in a bright light.
The monitor is lit by an LED backlit. Should the monitor begin to dim or flicker, contact your Ni-
kon service representative.