Filter
Top Products
138
Displaying Pictures with the Projector (Projector Mode)
Using the projector
4 Adjust focus for the projected picture.
Turn off unnecessary lights.
Slide the projector focus slider left or right to
adjust picture focus.
5 Switch the picture with the remote control (supplied).
Point the remote control at the infrared receiver on the front or rear of the camera (A 4,
5) within a distance of approximately 5 m (16 ft.).
The multi selector on the camera can also be used to operate the projector (A 140).
6 Press the P button to end projection.
Projection also ends if the A button is pressed to switch to shooting mode, or the c
button is pressed to switch to playback mode.
B Notes on Using the Projector
• Be sure to read and follow the projector warnings on page iv.
• Be aware that the camera and battery will become hot in projector mode. Allow the camera to
cool before using it again when the projector has been used for an extended period of time.
• When the battery is low, the camera automatically adjusts projection brightness to save power.
• Projection is not enabled while the playback-mode selection menu (A 10) is displayed, even
when the P button is pressed.
Infrared emitter Infrared receiver Display the previous picture
Display the next picture