Filter
Top Products
157
Troubleshooting
Technical Notes
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Shooting
Monitor turns off, and
the power-on lamp
blinks rapidly.
Battery temperature is high. Turn off camera and allow
battery to cool down before resuming use. After the
lamps blink for three minutes, the camera will turn off
automatically. Pressing the power switch also turns off
the camera.
17
Camera does not
respond to remote
control operation.
• Battery of the remote control is exhausted.
• Point the remote control at the infrared receiver on
the front or rear on the camera at the distance within
approximately 5 m (16 ft.).
• When Smile timer is set to On in smart portrait
mode, and the camera recognizes human faces,
remote control operation is not available.
• The shutter may not be released when attempting to
use the remote control to take pictures of scenes
exhibiting severe backlighting.
7
35,
138
50
–
Problem Cause/Solution A
No picture taken when shutter-
release button is pressed.
• When camera is in playback mode, press the
A button or the shutter-release button.
• When menus are displayed, press the d
button.
• Battery is exhausted.
• When flash lamp blinks, flash is charging.
10, 28
12
22
31
Problem Cause/Solution A