Nikon D3000KIT Film Camera User Manual


 
29
s
Step 5: Shoot
Smoothly press the shutter-release button the rest of
the way down to release the shutter and record the
photograph.
The access lamp next to the memory
card slot cover will light and the photograph will be
displayed in the monitor for a few seconds (the photo
will automatically clear from the display when the
shutter-release button is pressed halfway).
Do not
eject the memory card or remove or disconnect the
power source until the lamp has gone out and recording
is complete.
A The Shutter-Release Button
The camera has a two-stage shutter-release button.
The camera focuses when the shutter-
release button is pressed halfway.
To take the photograph, press the shutter-release button
the rest of the way down.
A The Built-in Flash
If additional lighting is required for correct exposure in i mode, the
built-in flash will pop up automatically when the shutter-release
button is pressed halfway.
If the flash is raised, photographs can only
be taken when the flash-ready indicator (M) is displayed.
If the flash-
ready indicator is not displayed, the flash is charging; remove your
finger briefly from the shutter-release button and try again.
To save battery power when the flash is not in use, return it to its
closed position by pressing it gently downward till the latch clicks
into place.
A Using the Flash
For more information on using the flash, see page 58.
Access lamp