Filter
Top Products
43
Additional Information
A characteristic of electronic cameras
In rare cases, when strong static electricity or the like is applied to
the camera, the camera may not work properly.
If this happens, remove the battery and reinstall it.
When the battery is removed, the date/time are reset. Set them
after reinstall the battery. ( p. 41)
Check points and solution
aThe battery is installed with wrong polarities.
→Install it with the correct polarities.
aNo battery or dead battery.
→Install a new battery.
aThe letter “ ” blinks or lights up.
→Remove the film and load it again.
aYou are out of the remote control working range.
→Operate the remote control in a range within
5 m facing the camera.
aTwo or more minutes have elapsed since you set
the camera to Remote Control mode.
→Set the camera to Remote Control mode again.
aThe remote control is operated in backlit.
→Change the position of the remote control.
aThe service life of the battery in the remote
control has lapsed (10 years).
→Visit an authorized Nikon dealer or service
center to change it (at your expense)
No indicator
appears even
when the camera
is turned on.
The numeral “ ”
does not appear
even when film is
loaded.
The shutter
cannot be
released using
the remote
control.
Problem
Remote control (Optional)
LCD panel
Ref. page
12
12,13
14,15
39
39
39
—