Filter
Top Products
9
Preparation—Installing and Charging the Battery Pack
Using the COOLWALKER MSV-01 from an AC Power Supply Source
• To use your MSV-01 from an AC power source, connect the AC adapter and turn the power switch on.
• Charging is not performed when the MSV-01 is on with the AC adapter connected.
Removing and Installing the Battery Pack
• Before removing the battery pack make sure that the MSV-01 is turned off and the AC adapter is dis-
connected.
• When removing or attaching the battery pack, always observe the correct procedure described in this
manual to avoid damaging the battery terminals.
• Do not touch the battery pack terminals to avoid damaging them and prevent them from becoming
dirty.
• Do not leave unattended or transport the MSV-01 with the battery pack removed.
• Do not remove the battery pack when using the MSV-01 from an AC power supply source. If you acci-
dentally connect the AC adapter to the MSV-01 with the battery pack removed, the power-on lamp
will light up (orange). Make sure that the MSV-01 is off, disconnect the AC adapter and attach the
battery pack.
The AC Adapter
• Accidental disconnection of the AC adapter while the MSV-01 is turned on may damage the device.
When using the device, be careful not to disconnect the AC adapter.
• Be sure to read and follow the precautions in the "For Your Safety" ( i-iii) section and notes on
using the AC adapter ( 59) in this manual.
The Battery Pack
• When transporting or storing a spare battery pack, place it in the supplied case.
• On handling the battery pack, refer to the Li-ion Polymer Battery EN-EL6 manual. When installing or
removing the battery pack, be sure to read and follow the precautions in the "For Your Safety"
( i-iii) and "Notices" ( iv - vi) sections, as well as notes on using the battery pack in the
"Batteries" ( 60) section in this manual.
(2) Open the interface connector cover, and connect
the supplied AC adapter to DC-in connector (
➈).
Plug the AC adapter into an outlet (
➉).
(3) Charging will begin immediately.
While the battery is charging, the power-on lamp
flashes in orange. Charging is complete when the
orange power-on lamp stops flashing.
An exhausted battery can be fully charged in
about 4.5 hours.
(4) Remove the AC adapter, while the MSV-01 is still
off.
➈
➉