Filter
Top Products
35
Advanced Operation—Viewing Pictures on TV
Advanced Operation
Viewing Pictures on TV
The supplied EG-CW1 audio/video (A/V) cable can be used to connect the MSV-01 to a television
or VCR.
Choosing a Video Mode
The Video mode option in the MSV-01 SET UP menu offers a choice of NTSC and PAL standards
( 54). Be sure that the selected mode matches the standard used in the video device.
When Connected to a Television
Accidental disconnection of the A/V cable or AC adapter while the MSV-01 is turned on may damage the device.
Place the main unit on a flat and stable surface and be careful not to accidentally disconnect the cables.
1 Turn the MSV-01 off
Turn the MSV-01 off before connecting or disconnect-
ing the A/V cable.
2 Connect the A/V cable
Open the interface cover and insert the black plug of
the supplied A/V cable into the audio/video-out inter-
face connector of the MSV-01.
Insert the yellow plug into the video-in jack and the
white plug into the audio-in jack on the television or
VCR.
3 Tune the television or VCR to the video
channel or external input
If in doubt, consult the documentation for your televi-
sion or VCR.
4 Turn the MSV-01 on
The MSV-01 monitor will remain off and the television
will display the menu normally shown in the monitor.
Operate the remote control unit pointing it at the
remote control sensor located beside the memory
card slot of the MSV-01 main unit.