Filter
Top Products
10
Preparation—Power-ON/OFF
Power-ON/OFF
To power the MSV-01 on, press and hold down the power switch ( 3) for about 2 seconds. The
monitor will turn on showing the welcome screen, then it will switch to the main menu. To turn
the MSV-01 off, press and hold down the power switch for about 2 seconds when the power-on
lamp is on.
The MSV-01 status is shown as follows:
Turning the Power On/Off
• Be sure to turn the MSV-01 off, when:
- inserting or removing a memory card;
- connecting or disconnecting the A/V cable;
- removing the battery pack.
• The MSV-01 will not go off if the power switch is pressed while the copy ( 13, 26, 36), or HDD/
memory card format ( 55) operation is in progress and "
Copying...
" or "
Formatting...
" is
displayed on the monitor.
Auto Power Off
If no operation is performed for one minute (default setting) when running on battery power, the MSV-
01 will turn off automatically.
• This setting can be changed using the Auto power off option in the SET UP menu ( 54).
• The Auto power off function is disabled when the MSV-01 is running on the AC power supply.
Checking the Battery Level
The battery status is displayed at the bottom of the MSV-01 monitor.
During operation, the display may temporarily indicate a lower than the actual remaining battery
charge.
Using the MSV-01 from an AC Power Source
To power the MSV-01 continuously for extended periods, use the DSA-0151F-05 AC adapter. Do not,
under any circumstances, use another make or model of an AC adapter. Failure to observe this
precaution could result in overheating or in damage to the MSV-01.
Power-on Lamp COOLWALKER MSV-01
ON (green) Power ON
OFF Power OFF
Blinking (orange) Charging (OFF)
On (orange) Charging completed (OFF)
Display Description
Battery is fully charged.
Battery power is low. The power may go off dur-
ing operation.
Battery is exhausted. Recharge or use the AC
adapter immediately.
Not displayed The MSV-01 is operating from an AC power
source.
Power switch Power-on lamp
Battery status