Filter
Top Products
TTL AUTO FLASH OPERATION
The difference between Automatic Balanced Fill-Flash and
8tandard
TIL
Flash
is
in
whether the flash output
level
is
automatically compensated or not. Operation
is
the same,
1.
8et
camera's metering system and exposure mode, referring
to previous table,
2. Turn 8peedlight on,
If
Wide-Area focus
is
set on the camera,
it
automatically
switches over to
8pot
Area focus when the 8peedlight
connected to the camera
is
tumed on, In this case, 0 blinks
in
the LCD panel, and G appears inside the viewfinder.
•
If
8peedlight
is
not set at
TIL
auto flash mode,
in
Programmed Auto exposure mode,
FE
E blinks to alert that
Programmed Auto exposure can be used only for
TIL
auto
flash,
3.
8et
8peedlight's mode selector to
TIL,
• With 8B-23, setting mode selector to
TIL
simultaneously
turns 8peedlight on,
4. Look through the viewfinder, compose picture and lightly
press shutter release button, while confirming exposure
indication
in
the LCD readout.
In
autofocus operation, also
confirm that in-focus indicator ( • or
~
••
) appears,
• For exposure alert, see next page,
• In Programmed or 8hutter-Prioroity Auto exposure mode,
if
you
fail
to have set the lens to minimum aperture,
FE
E
blinks and shutter
is
locked,
118
5. Confirm exposure and shooting distance,
Refer to shooting distance bars of
8B-25
or 8B-24, or flash
shooting distance range table
of
8B-23, 8B-22 or 8B-20,
For details, see 8peedlight's manual.
6. Confirm that ready-light
is
on, then fully depress shutter
release button to take a picture,
If ready-light blinks for a few seconds after shooting:
Flash has fired at maximum output, but the light might
have been insufficient for correct exposure of subject.
Confirm shooting distance and, if necessary, move closer
to subject, or select wider aperture,