Button operations
EN
15
Press 1F in shooting mode, and then use the arrow pad 43 to
adjust the exposure and press o to confirm the setting.
• Adjustable from -2.0EV to +2.0 EV
Press 3# in shooting mode to select the flash setting.
Press o to confirm your selection.
Press 2Y in shooting mode to select on and off for the self-timer.
Press o to confirm your selection.
• After pressing the shutter button completely, the self-timer lamp lights for approximately 10
seconds, blinks for approximately 2 seconds, and then the picture is taken.
• To cancel the self-timer, press 2Y.
• Self-timer shooting is automatically canceled after one shot.
In playback mode, select the picture you want to erase, and press 2S.
• Once erased, pictures cannot be restored. Check each picture before erasing to avoid
accidentally erasing pictures you want to keep.
g “0 Protecting pictures” (P. 28)
• You cannot erase a single frame during close-up playback and index display.
1F button Changing picture brightness
3# button Flash shooting
AUTO (Auto-flash) The flash fires automatically in low light or backlight conditions.
! Red-eye reduction flash This emits pre-flashes to reduce the occurrence of red-eye in
your pictures.
# Fill-in flash The flash fires regardless of the available light.
$ Flash off The flash does not fire even in low light conditions.
2Y/S button Self-timer shooting/Erasing pictures
Y Self-timer shooting
Y OFF Cancel the self-timer.
Y ON Set the self-timer.
S Erasing pictures
9
+
2.0
2.0
OK
SET
P
+
2.0
Activate the setting.
3: Brighten
4: Darken
0
a
d4332_e_0000_7.book Page 15 Tuesday, January 9, 2007 2:07 PM