22 En
En
AUTO PLAYBACK
You can view images stored on the card automatically in their stored order
as a “slide show”. This function is useful when you want to view images in
sequence.
1 Close the lens barrier and press the
button.
The camera turns on in the Play mode.
2 Press the button.
The monitor shows the Play menu.
3 Select [PLAY] using the / buttons and press the button.
4 Select [
] using the / buttons and press the button.
5 Select [START] using the
/ buttons and press the button.
Auto Playback starts by displaying each image for 3 seconds.
To cancel Auto playback, press the
button. Press the button again to
exit the menu.
Note
• If you display the Play menu while the monitor shows a movie, [ ] appears
instead of [ ]. Auto playback can only be started when a still picture is
displayed.
• If the camera is powered by the batteries on the Auto Playback mode, it will
turn off automatically if left unoperated for about 30 minutes.
ERASING ALL IMAGES
1 Close the lens barrier and press the button.
The camera turns on in the Play mode.
2 Press the button.
The monitor shows the Play menu.
3 Select [SETUP] using the / buttons and press the button.
4 Select [
] using the / buttons and press the button.
5 Select [
ALL ERASE] using the / buttons and press the
button.
6 Select [
ALL ERASE] using the / buttons to and press the
button.
All the images are erased.
Caution
• Protected images can not be erased.
• If a write protect seal is attached to the SmartMedia card, the images on the
card can not be erased.
• Erased images can not be restored. Check each image before erasing to avoid
accidentally erasing images you want to keep.
1/Basic05_C2-E.65E 01.8.17, 10:07 AM22