Filter
Top Products
25
RECORDING MOVIES AND PLAYING THEM BACK
Ⅵ Recording movies
1
Set the Mode dial to .
2
Compose the picture by turning the
camera towards the subject.
3
Press the shutter button halfway to lock
the focus and exposure.
● The AF confirmation mark will light up
and the camera will beep.
4
Press the shutter button fully. Recording
will start. To stop recording, press the
shutter button fully again.
● The mark will light up in red while shooting movies.
●
You cannot take movies if the entire image memory gauge is lit up.
● When recording starts, correct focusing and exposure is maintained
continuously.
● The card access lamp will blink and the camera will begin storing images onto
the card.
● You cannot take the next movie until the camera is finished storing the current
one, even if the memory indicates that there is sufficient memory.
●
To record the next movie picture:
Wait until the card access lamp goes off and writing of movie pictures into the card is
finished.
F2.8 1/30 0.0
[
SM
]
Seconds remaining
Memory gauge
Ⅵ Displaying movies
Select images with the mark using the Arrow pad. Press (Menu button).
Select MOVIE PLAY, then press to select START. Press the OK button to read the
data from the card. When the card access lamp stops blinking, the movie display
starts. To pause, press the OK button while displaying movies. To restart the movie
playback, press the OK button again. Use the Arrow pad to display the previous/next
frame. To end the movie display, press (Menu button). The menu display is
restored.
PROTECTION
Set the mode dial to . Display the picture you want to protect. Press the OK button.
The displayed picture will then be protected. will appear on the monitor.
SINGLE FRAME ERASURE
Switch the mode dial to .Select the images you want to erase using the Arrow pad.
Press (Erase button). A message asking you to confirm the erasure will appear.
Make sure that YES is selected, then press the OK button.