Filter
Top Products
129
Chapter 10
Troubleshooting (Cont.)
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
The picture is too dark.
1 The flash was blocked
by a finger.
2 The subject was out of
the working range of
the flash.
3 The flash mode was
set to the Off mode.
4 The subject was too
small and was backlit.
5 The sequential mode
was used.
1 Hold the camera correctly,
keeping your fingers away
from the flash.
2 Shoot within the flash
working range.
3 Press the flash switch to
raise the flash.
4
Set the flash to Fill-In mode. Or,
use the spot metering mode.
5 Higher shutter speeds are
used when the sequential
mode is selected which may
result in pictures that are
darker than usual.
P. 31
P. 62
P. 62
P. 62, 65
P. 71
The colors of pictures taken indoors look unnatural.
1 Indoor lighting can
affect the picture’s
colors.
2 There is no white in the
subject.
3 The white balance
setting is wrong.
1 Set the white balance
according to the lighting.
2 Try to include something
white in the picture or shoot
using the Fill-in flash mode.
3 Adjust the white balance to
the light source.
P. 85
P. 62
P. 85
1 The flash mode was
set to the Fill-in flash
mode.
2 The subject was
excessively illuminated.
1 Select a flash mode other
than the Fill-in flash mode.
2 Adjust the exposure
compensation or change the
camera position toward the
subject.
P. 62
P. 84
The picture is too bright.