Filter
Top Products
E-13
En
Removing the TTL cable connector cap
ț To perform TTL flash shooting in combination with the
separately available Electronic Flash Case, remove
the TTL cable connector cap as described below.
1Remove the TTL cable connector cap from the
Case.
2Connect the Electronic Flash Case’s underwater
TTL cable to the TTL connector on the Case.
Remove.
Turn counter clockwise.
TTL cable
connector cap
Insert into the
connector.
Underwater
TTL cable
Use this mark to
align the position.
Turn the threaded section of the connector
clockwise lightly until it is stopped.
1
2
❈For details on the TTL cable and hot shoe cable, refer to the instruction manual provided
with the Electronic Flash Case.
---- How to attach the TTL cable connector cap to the case ----
Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL
cable connector. To secure the cap, gently turn it clockwise until it stops.
Gently turn the cap
clockwise until it stops.
Put the cap
on the case.
Cleaning the TTL connector
If the threaded sections of the TTL cable and TTL cable connector stick to each other, the
cable may disconnect from the connector. To prevent this, apply O-ring silicon grease
(provided with this case) to the threaded sections.
For details, see the maintenance description on page E-32 of this manual.
:•If you cannot disconnect the TTL cable, do not use force to disconnect it.
Contact Olympus for support.
CAUTION
:•If the TTL cable connector cap is loose, water penetration may result. Be
sure to gently turn the cap until it stops to make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too tight, it may be
difficult to loosen and remove it.
CAUTION