Filter
Top Products
E-16
En
3. Installing the digital camera
Check the digital camera.
Check the digital camera before loading it in the Case.
Battery Confirmation
Underwater shooting can reduce battery life because the picture has to be checked on
the LCD monitor before and after shooting. Make sure that you have sufficient remaining
battery capacity before use.
Check the remaining number of pictures
Check that the image storage medium has enough room for the number of pictures you
want to take.
Remove the hand strap and lens cap from the digital camera
If a strap or lens cap is attached to the digital camera, it must be removed before loading.
Remove the eyecup from the digital camera.
The Case allows you compose your shots in the pickup
viewfinder.
To improve the view of the pickup viewfinder, remove the
camera’s eyecup before loading it in the Case.
Remove the filter from the digital camera
If a filter is attached to the lens of the digital camera, remove the filter before loading the
digital camera in the Case.
Note In order to avoid missing photo opportunities due to an exhausted battery, you
should always a fresh fully charged battery before each dive.
:Be sure to remove the eyecup before loading the digital camera. Otherwise,
the rear lid of the Case cannot be closed tightly causing water leakage.
CAUTION
:•If the digital camera is loaded without removing the strap or lens cap, it may
get caught between the Case lids and cause water leakage.
•When removing the strap and/or lens cap, handle the digital camera
carefully. OLYMPUS IMAGING CORP. shall not be responsible for damage
caused by improper handling.
CAUTION
:The digital camera cannot be loaded in the Case while the filter is attached
to the lens. Be sure to remove the filter before loading.
CAUTION