Filter
Top Products
EN 19
En
How to attach the camera table to the digital camera
In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
Using the UFL-2 underwater electronic flash with the underwater
optical fiber cable
1 Set the RC mode of the camera to ON so that the camera’s built-in flash is activated.
2 Load the camera in the Case with the camera’s built-in flash popped up.
Refer to the UFL-2 instruction manual for the UFL-2 operation.
1 The eyecup and the hot shoe cover of the digital
camera can be stored in the camera table.
2 Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera’s
tripod screw hole for attaching.
3 The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
Up
Down
Front
Rear
PT-E05_EN.Book Page 19 Tuesday, June 17, 2008 11:11 AM