Filter
Top Products
EN 30
En
Unload the digital camera
First, open the open/close dial of the Case and then open the rear lid carefully. Next, pull out the zoom
dial and mode dial. Gently remove the loaded digital camera, while holding it with both hands.
To unload the digital camera, reverse the procedure described in “Insert the digital camera in the
Case” (P. 21) of this manual.
1 Turn the open/close dial on the Case.
2 Disconnect the hot shoe cable if it is
connected to the camera, then remove
the Case’s zoom and mode dials so that
they do not interfere with removal of the
camera, and take out the camera.
CAUTION:
• After opening the Case, always place it so that the O-ring surface is facing up. If the O-ring surface is faced
down, foreign matter and dirt may attach to the O-ring and O-ring contact surface. This may cause the Case
to leak the next time it is used underwater.
• For the picture storage and other procedures, refer to the camera’s instruction manual.
• Be sure to pull out the zoom dial and mode dial of the Case before taking the digital camera out so that the
dials do not get in the way. Otherwise, if the digital camera is removed forcefully, the Case or digital camera
may be damaged.
PT-E05_EN.Book Page 30 Tuesday, June 17, 2008 11:11 AM