Filter
Top Products
Using OLYMPUS Master
143
Connecting the camera to a computer
9
Windows
1 Insert the CD-ROM into the
CD-ROM drive.
• The OLYMPUS Master setup screen is
displayed.
• If the screen is not displayed,
double-click the “My Computer” icon
and click the CD-ROM icon.
2 Click the “OLYMPUS Master”.
• The QuickTime installation screen is
displayed.
• QuickTime is required to use
OLYMPUS Master. If the QuickTime
screen is not displayed, QuickTime 6 or
later is already installed on the
computer. In this case, go to Step 4.
Note
• Operation is only guaranteed on a Macintosh equipped with a built-in USB port.
• QuickTime 6 or later and Safari 1.0 or later must be installed.
• Be sure to remove the media (drag & drop onto the trash icon) before
performing the following operations. Failure to do so could result in unstable
computer operation and the need to reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera’s card cover
• Open the camera’s battery compartment cover