- 61 -
Quick Start
1 Press and hold down the QUICK START
button until the display on the LCD monitor/
viewfinder disappears.
The quick start lamp E flashes green and the unit goes into
Quick Start Standby Mode.
2 Press the QUICK START button.
The quick start lamp E goes off and the unit is put into
recording pause about 0.6 seconds.
≥ When in Quick Start Standby Mode about 80% of the power used in recording pause mode
is being consumed, so the recording time will be reduced.
≥ This unit is turned off after approximately 30 minutes elapse in Quick Start Standby Mode.
≥ Quick Start Standby Mode is cleared when the mode switch is set to .
≥ Depending on the recording conditions and menu settings, time for Quick Start may be longer
than 0.6 seconds.
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approximately 1k.
Recording
Useful functions
ZEBRA
BARS
DISP/MODE CHK
QUICK START
A DISP/MODE CHK button
B ZEBRA button
C QUICK START button
D BARS button
AG-AC90-VQT4M99_mst.book 61 ページ 2012年9月25日 火曜日 午後12時6分