Filter
Top Products
53 (E)
EDITING
ENGLISH
g Listening to sound that has been
dubbed
You can switch between the sound that has been
dubbed and the sound heard during shooting using
the 32K (12bit) AUDIO item setting on the PLAY-
BACK FUNCTION screen. (P67)
ST1:
The sound heard during shooting is played back.
ST2:
The sound that has been dubbed on a recording
is played back.
MIX:
Both the sound heard during shooting and that
you have dubbed on a recording are played back
at the same time.
g Performing audio dubbing as you
listen to it
You can monitor the sound by setting “ST2” while
audio dubbing is temporarily suspended.
If you use headphones when performing audio dub-
bing on a recording using mic input, you can listen
to the sound being dubbed.
When you perform audio dubbing using line input
(from the audio component connected to the
AUDIO IN/OUT jack), you can listen to the sound
being dubbed through the speakers.
g Using the counter memory func-
tion to edit dubbed sound
First reset the counter memory display at the
position where the audio dubbing is to end.
(P48)
Rewind the tape to the position where the audio
dubbing is to start, and start the dubbing.
The tape then stops automatically at the position
on the tape where the counter memory display
was reset.
g Adjusting the audio input level
Use the procedure described for “Adjusting the mic
input audio level” (P42) to adjust the audio level of
mic input.
• You cannot adjust the level of A_IN input.
g Adjusting the audio output level
Use the procedure described for “Adjusting the
headphone volume” (P42) to adjust the audio level
output from the headphones and speakers.
1
2
3
Note
In the LP mode, you cannot dub after recording as the
track on the tape is thinner than the head.
Input channels and the tracks recorded
Audio mode Input channel Audio track
AG-DVC60E_En.fm 53 ページ ２００４年９月２日 木曜日 午後１時４３分