Filter
Top Products
–48–
Warning/Status Displays in the Viewfinder and Display Window
Selecting the desired item
1 Press the SHIFT/ITEM button.
Each time this button is pressed, the cursor (arrow) which indicates the selected item
moves to the next item.
The item can also be selected using the UP and DOWN buttons as follows.
Changing the settings
Press the UP button to increase the setting.
ÁThe setting is incremented by 1 level each time
the UP button is pressed.
Press the DOWN button to decrease the setting.
ÁThe setting is decremented by 1 level each time
the DOWN button is pressed.
Changing the ON/OFF selection
The setting switches to ON or OFF each time the UP (or DOWN) button is pressed.
Returning to the default settings
The unit can be returned to the default settings (the settings when shipped from the factory or
the engineer mode settings) by pressing the UP (or DOWN) button at the DATA RESET page of
engineer modeF.
However, care should be taken as the flare and shading adjustment values cannot be returned
to the default settings.
Quitting the menu
Set the MENU SET/OFF switch to OFF.
ÁThe setting menu disappears from the viewfinder screen and the displays indicating the unit’s
current status appear at the top and bottom of the viewfinder screen.
FEngineer mode
FThe menu for this mode is opened by holding down the SHIFT/ITEM and UP buttons simulta-
Fneously and then setting the MENU SET/OFF switch to the “SET” position.
Cursor
Movement order
-
M
ARKER
-
¢
CENTER
M
ARK :
O
N
SAFETY Z
O
NE : 1
†
SHIFT
PAGE
DOWN
UP
MENU
TCG
OFF
R-RUN
F-RUN CH1
SET
CH2
CH1/2
SET
FRONT
010
MIC
MIC
AUTO
MAN
LINE
AUDIO IN
CH1
AUDIO
LEVEL
MONITOR
AUDIO SELECT RET VIDEO
REAR
EXT
INT
MIX
ST
010
CH2