Filter
Top Products
12
Connections
System configuration
Camera:
AK-HC3800
Optical fiber multi cable
(sold separately)
Camera control unit (CCU):
AK-HCU200
ROP cable
(sold separately)
ROP:
AK-HRP200
Equipment connections
Before proceeding with the connections, check that the power of the
unit and camera is OFF.
Use the optical fiber multi cable to connect the unit and camera.
Connect only the AK-HC3800 camera: Do not connect any other
model.
Use a dedicated cable to connect the unit to the ROP.
When the unit’s power switch is set to ON and then the camera’s
power is set to ON, the camera can be controlled using the ROP.
The camera statuses are shown on the picture monitor.
Refer to “Picture monitor (PM) displays” of <Operations and
Settings>.
When you configure the unit’s settings by menu operations, the menu
screens are displayed on the picture monitor.
Refer to “Menu operations” of <Operations and Settings>.
When you configure the unit’s settings by Web settings from a
computer, use a crossover cable (10Base-T or 100Base-TX) to
connect the computer directly to the unit.
Refer to “Web settings” of <Operations and Settings>.
Before disconnecting the cables from the camera and ROP, turn off
the camera’s power and then turn off the unit’s power.
HD/SD SDI OUT
PROMPT
HD/SD-SDI RET
Camera:
AK-HC3800
Picture monitor
(HD/SD-SDI)
Computer
Picture monitor
(Analog SD)
ROP:
AK-HRP200