TXD: Data from camera to remote controller.
RXD: Data from remote controller to camera.
N Swivel stand control signal input connector [P/T CONT (RJ-45)]
Connects the swivel stand control signal output of the pan-tilt control panel (AW-
RP301).
O Monitor signal output connector [Y/G, Pb/B, Pr/R] (BNCk3)
Outputs the analog signal from the camera.
The output can be changed to R, G, B/Y, Pb, Pr by the camera menu setting.
P Synch signal input connector [G/L IN] (BNCk1)
Inputs the sync signal to the camera. Input 3-value SYNC as the synch signal.
Q Tally signal input connector [TALLY IN] (2-pin connector block)
Connected to the tally connector from the system. When the HOT connector is at GND
level, the tally LED is lighted.
Controls and their Functions
M Camera connector [CAMERA I/F]
Connected to the camera (AK-HC900P) with the attached cable.
