Panasonic AW-RP120G Security Camera User Manual


 
37
Selecting a camera group
This unit allows you to register up to 100 remote cameras as control
targets by configuring the connection settings for each of the camera
numbers CAM1 to CAM100. To select a remote camera to control from
these cameras, you need to select the camera group to which it belongs
beforehand.
Camera
group
Camera numbers
Camera
group
Camera numbers
1 CAM1 to CAM10 6 CAM51 to CAM60
2 CAM11 to CAM20 7 CAM61 to CAM70
3 CAM21 to CAM30 8 CAM71 to CAM80
4 CAM31 to CAM40 9 CAM81 to CAM90
5 CAM41 to CAM50 10 CAM91 to CAM100
Selecting a camera group
1. Press the mode selection button [SELECT] to turn off
the button indicator.
2. Hold down a camera selection button
[CAMERA SELECT/GROUP SELECT] to select the
camera group to which the remote camera you want to
control belongs.
When a camera group is selected, the corresponding camera group
indicator [CAMERA GROUP] lights and the indicator of the camera
selection button that was held down blinks. When the camera
selection button lights, the remote cameras can be operated from
the unit.
1
2
Example: When camera group “10” is selected
When selecting a camera group, hold down the camera
selection button.
After a camera group is selected, it takes approximately
5 seconds in the case of IP connections and approximately
20 seconds in the case of serial connections for operation of
the remote cameras to become possible.
(When AW‑HE50, AW‑HE60 and AW‑HE120 are connected,
and they are all powered on.)
Notes