Filter
Top Products
Operating Instructions
99
When you set [FTP] for Transfer Method
Select [FTP], and click [Next>]. The following page is displayed.
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Setting Description
Server IP
Address or
Host
Name
*1
• If you set a server IP address, set 4 numbers (0—255) and 3
periods, such as "192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available. Or set a host name (1—
255 characters).
• You can set an IPv6 address.
Port No. • Enter the number (1—65535). Usually set to 21.
Login ID
*2
• If your ISP requires a login ID, set it (0—63 characters).
Password
*2
• If your ISP requires a password, set it (0—63 characters).
Login
Timing
• Select the login setting for the FTP server. If you set [One
Time] and the image buffer frequency value is set within 1
minute, the camera logs in to the server only once. This can
reduce transfer time.
Upload File
Name
*1
• Set a file name on the FTP server to receive the transferred
files. Enter 1—234 characters. Server directories can be
included by entering "\". The directories to be specified should
be created beforehand. (E.g. NetworkCamera\image)