Filter
Top Products
1. CAMERA SETUP MENU
This camera utilizes a user setup menu that is displayed on-screen.
The setup menu contains various items that form a tree-type structure as shown below.
It is described in the following section : “2. SETUP OPERATION.”
-12-
CAM SETUP
Camera
ID
ON/OFF
Camera
ID
Editing
SUPER-D
ON
Camera ID
Display
Position
Manual
Level
Selection
SUPER-D
OFF
Light
Control
ALC ELC
Manual
Mask Area
Selection
Manual
Level
Selection
INT
Manual
Selection
Shutter
Speed
AGC
ON/OFF
Manual
Mask Area
Selection
V. Phase
Manual
Adjustment
SYNC
INT/LL
LL
Manual
Selection
VD2
Automatic
Selection
SETUP DISABLE → SETUP ENABLE →
SETUP
Left Button
Set Switch
Right Button
Down Button
Up Button
(U) (Up Button):
This button is used to move the cursor
upwards. Use this button to select an item
or adjust the parameters.
(D) (Down Button):
This button is used to move the cursor
downwards. Use this button to select an
item or adjust the parameters.
(R) (Right Button):
This button is used to move the cursor to
the right. Use this button to select or adjust
the parameters of the selected item. The
parameter changes each time this button is
pressed.
(L) (Left Button):
This button is used to move the cursor to
the left. Use this button to select or adjust
the parameters of the selected item. The
parameter changes each time this button is
pressed.
(S) (Set Button):
This button is used to set the determined
parameter. If the item has its own setting
menu (as indicated by ), press this but-
ton to display the setting menu.
• All Reset Operation
All Reset allows you to reset all setup menu items
to the factory settings if you are unsure about the
correct settings. Proceed as follows:
(1) Make sure that the CAM SETUP menu is not
displayed (a camera picture is displayed).
(2) While pressing both (L) and (R), press
(S) for a few seconds. The words ALL
RESET momentarily appear on the monitor.
At this time all adjustments and parameters are
reset to the factory default settings.
2. SETUP OPERATION
This camera utilizes a user setup menu (CAM
SETUP) that is displayed on the monitor.
To set items on the CAM SETUP menu, use the fol-
lowing buttons on the side panel.