Filter
Top Products
Preparation
19
VQT0Q09
Attaching the Lens Cap/Strap
∫ Lens Cap (supplied)
1 Pass the string through the hole
on the lens cap.
2 Pass the string through the hole
on the camera.
3 Attach the lens cap.
∫ Strap (supplied)
1 Pass the strap through the hole at
the Strap Eyelet.
2 Pass the strap through the
stopper and fasten the strap.
A: Pull the strap 2 cm or more.
• Attach the strap to the other side of the
camera being careful not to twist it.
• Check that the strap is firmly attached to
the camera.
• Attach the strap so that you can see
“L
UMIX” logo.
• When you turn the camera off, carry the camera or play back the pictures, attach the lens
cap to protect the surface of the lens.
• Detach the lens cap before turning on the camera in the recording mode.
• When the mode dial is set to one of the recording modes and the camera is turned on
with the lens cap attached, the message [REMOVE LENS CAP AND PRESS 1
BUTTON] appears. Press 1 button after detaching the lens cap.
• Be careful not to lose the lens cap.
VQT0Q09ENG.book 19 ページ ２００５年１月２５日 火曜日 午後８時１７分