Filter
Top Products
Connecting to other equipment
80
VQT0V86
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer]
(for Windows
®
) in the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use Windows
98/98SE, install the
USB driver and then connect it to the
computer.
For information about installing [LUMIX
Simple Viewer] etc., refer to the separate
operating instructions for PC connection.
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC5; optional)
• Use a battery with sufficient battery power
or the AC adaptor (DMW-AC5; optional).
• Turn the camera off before inserting or
removing the cable for the AC adaptor
(DMW-AC5; optional).
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [2] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
D: This message appears during data
transfer.
3 Press 3 to select [PC] and then
press [MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PC] in advance, it is not
necessary to set this every time you
connect to a PC. (P20)
• If you set [USB MODE] to [PictBridge
(PTP)] and then connect the camera to
the PC, messages may appear on the
screen of the PC.
DIGITAL
AV OUT
DC IN
ACCESS
USB MODE
SELECT SET
MENU
PictBridge(PTP)
PC
PLEASE SELECT
THE USB MODE.
/SET
MENU
VQT0V86ENG.book 80 ページ ２００６年１月３０日 月曜日 午前９時４６分