Filter
Top Products
VQT3A36
172
Others
If you use the stereo microphone (DMW-MS1; optional), you can switch to either stereo or
monaural sound recording.
It is also possible to reduce the wind noise efficiently by switching the [WIND CUT OFF/
ON] switch to [ON].
Battery Check Lamp [BATTERY]
•
When the Off/On Mode Selector Switch is changed from [OFF] to [MONO] or [STEREO], the
Battery Check Lamp [BATTERY] will light temporarily if there is still plenty of power in the
battery. If the Battery Check Lamp [BATTERY] does not light temporarily, replace the battery
with a new one.
Note
•
While the external microphone is connected, [ ] is displayed on the screen.
• When the external microphone is connected, [MIC LEVEL DISP.] (P128) is automatically set to
[ON], and the mic level is displayed on the screen.
• When attaching the stereo microphone, do not hold only the stereo microphone because it may
detach from the camera.
• Set the wind noise reduction only on the stereo microphone side.
• Do not open the built-in flash when the stereo microphone is attached.
• The stereo microphone cannot be used while the external flash (optional) is in use.
• The stereo microphone cannot be used while the remote shutter (DMW-RSL1; optional) is in
use.
• Read the operating instructions of the stereo microphone for details.
By connecting the AC adaptor (DMW-AC8PP; optional) and the DC coupler (DMW-DCC8;
optional), and then plugging them into an electrical socket, you can connect this unit to a
PC or printer and use without worrying about the capacity of the battery.
Note
•
Always use a genuine Panasonic AC adaptor (DMW-AC8PP; optional).
• Always use a genuine Panasonic DC coupler (DMW-DCC8; optional).
• Also read the operating instructions for the AC adaptor and DC coupler.
External Microphone (optional)
AC adaptor (optional)/DC coupler (optional)
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 172 ページ ２０１０年１０月１９日 火曜日 午前１１時３分