Filter
Top Products
16
VQT1A34
Before using
Adjust the length of the grip belt so that it fits your
hand, and hold it properly.
1 Flip the belt.
2
Put your hand through the grip belt.
A Rubber grip
1 Loosen the belt.
2 Put your hand through the belt as far as it
goes.
≥Slip your hand through the belt as far as it
goes so that your fingers will grip the
rubber area firmly.
3 Replace the belt.
≥Tighten up the belt so that your hand
remains firmly in place.
Rotate the lens hood
counter-clockwise A to remove it. In
order to attach it, place into slot B,
and then rotate it clockwise C.
≥Attach the MC protector or the ND filter of the
Filter Kit (VW-LF43NE; optional) in front of the
lens hood. Do not attach the other accessories
on the hood. (Except for the lens cap)
(Refer to the operating instructions for the Filter
Kit.)
(Be careful about the following.)
When 2 lens accessories, such as the ND filter,
are attached and the W/T lever is pressed toward
the W side, the 4 corners of an image will be
darkened. (Vignetting)
Using grip belt Lens hood
ACB
VQT1A34_GC_ENG.book 16 ページ ２００７年１月２７日 土曜日 午後１時４６分