Filter
Top Products
12
VQT1T93
Quick Guide
∫ Charging the battery
1) Connect the AC cable to the AC adaptor and
the AC outlet.
2) Insert the battery into the battery charger by
aligning the arrows.
∫ Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
A Insert the battery until it clicks and locks.
∫ How to turn on the power
Turn on the power by turning the mode dial to
or while pressing the lock release
button A.
≥ Rotate the mode dial while at the same time
pressing in the lock release button if changing
from OFF to another mode.
≥ Align with the status indicator B.
≥ To turn off the power, set the mode dial to OFF.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
≥ Check that the card access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥ When inserting an SD card, face the label side
C in the direction shown in the illustration and
press it straight in as far as it will go.
≥ When removing the SD card, press the center
of the SD card and then pull it straight out.
4) Securely close the SD card cover.
≥ Securely close it until it clicks.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging
completed
Card access lamp [ACCESS] A
≥ When this unit is accessing the card, the
access lamp lights up.
HDCHS100P-VQT1T93_ENG.book 12 ページ ２００８年７月１４日 月曜日 午後１時３６分