Filter
Top Products
133
VQT1T93
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ The unit will not operate unless the LCD monitor is opened
when the LCD/EVF select switch is set to LCD.
≥ Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the SD card or HDD
is being accessed may damage the data on the SD card or
HDD.)
The remote control does
not function.
≥ The button-type battery of the remote control may have run
out. Replace it with a new button-type battery. (l 21)
The remaining time
indication or the elapsed
time indication is not
shown.
≥ If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date etc are not displayed. (l 31)
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
≥ Rotate the mode dial to select .
≥ No recording is possible while the SD card’s write protect
switch is set to LOCK. (l 26)
≥ If there is no more available memory of the SD card or
HDD, free up some memory by deleting unnecessary
scenes or use a new SD card. (l 27, 83)
≥ If the SD card cover is open, this unit may not operate
normally. Close the SD card cover.
The unit arbitrarily stops
recording.
≥ Use an SD card that can be used for motion picture
recording. (l 26)
≥ If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (l 39)
≥ If the unit is exposed to strong vibrations or shocks while
recording on HDD, recording may stop to protect the HDD.
Recording starts but
stops immediately.
≥ The unit is disabled if the temperature is too high. Turn off
the power of the unit and wait until the unit cools down.
Auto focus function does
not work.
≥ Set the AUTO/MANUAL switch to AUTO.
≥ If you are trying to record a scene which is hard to bring into
focus in auto focus mode, use the manual focus mode to
adjust the focus. (l 70, 143)
HDCHS100P-VQT1T93_ENG.book 133 ページ ２００８年７月１４日 月曜日 午後１時３６分