144
VQT3B18
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the unit
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥ If normal operation is still not restored, detach the
power connected, and contact consumer support.
(l 170, 171, 172)
Item other than the
touched one is
selected.
≥ Calibrate the touch screen. (l 47)
The remote control
does not function.
≥ [REMOTE CONTROL] of the [SETUP] is [OFF].
(l 49)
≥ The button-type battery of the remote control may
have run out. Replace it with a new button-type
battery. (l 49)
The remaining time
indication or the
elapsed time
indication is not
shown.
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 42)
The unit arbitrarily
stops recording.
≥ Use an SD card that can be used for motion picture
recording. (l 23)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card. (l 47)
≥ If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (l 75)
Auto focus function
does not work.
≥ Switch to Intelligent Auto Mode.
≥ If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode, use the Manual
Focus Mode to adjust the focus. (l 36, 89)
HDC-SDT750&TMT750-P-VQT3B18_mst.book 144 ページ 2010年8月20日 金曜日 午後3時53分