Filter
Top Products
12
VQT2W55
Quick Guide
∫ Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ Charging the battery
A DC input terminal
1 Connect the AC adaptor to the DC input
terminal.
2 Connect the AC cable to the AC
adaptor, then the AC outlet.
≥ The status indicator will flash red at an
interval of 2 seconds, indicating that
charging has begun.
It will turn off when the charging is
completed.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
2) Open the SD card cover and insert
(remove) the SD card into (from) the
card slot B.
≥ Face the label side C in the direction
shown in the illustration and press it
straight in as far as it will go.
≥ Press the center of the SD card and then
pull it straight out.
3) Securely close the SD card cover.
≥ Securely close it until it clicks.
∫ Turning the unit on/off
Turning the unit on and off with the
power button
Press the power button to turn on the unit.
A The status indicator lights on.
≥ To turn off the unit, hold down the power
button until the status indicator goes off.
Turning the unit on and off with the LCD
monitor
Unit is turned on when the LCD monitor is
opened, and unit is turned off when it is closed.
∫ To turn on the unit
A The status indicator lights on.
Access lamp [ACCESS] A
≥ When this unit is accessing the SD
card, the access lamp lights up.
HDCSDX1_eng.book 12 ページ ２０１０年６月１１日 金曜日 午前９時２７分