Filter
Top Products
51
Do not use your Movie Camera near radio
transmitters or high-voltage lines.
≥If you record pictures near radio transmitters or
high-voltage lines, recorded images or sounds
may be adversely affected.
Do not use this Movie Camera for surveillance
purpose or other business use.
≥If you use the Movie Camera for a long period of
time, the internal temperature increases and,
consequently, this may cause malfunction.
≥This Movie Camera is not intended for business
use.
When you use your Movie Camera on a beach or
similar place, do not let sand or fine dust get
into the Movie Camera.
≥Sand or dust may damage the Movie Camera or
Cassette. (Care should be taken when inserting
and removing the Cassette.)
Do not spray insecticides or volatile chemicals
onto the Movie Camera.
≥If the Movie Camera is sprayed with such
chemicals, the camera body may be deformed and
the surface finish may peel off.
≥Do not keep rubber or plastic product in contact
with the Movie Camera for a long period of time.
Do not use benzine, thinner or alcohol for
cleaning the Movie Camera.
≥The camera body may be deformed and the
surface finish may peel off.
≥Before cleaning, detach the Battery or pull out the
AC Mains Lead from the AC mains socket.
≥Wipe the Movie Camera with a soft dry cloth. To
remove stubborn stains, wipe with a cloth that is
soaked in a detergent diluted with water and
afterward finish wiping with a dry cloth.
≥For storing or transporting the Movie Camera,
place it in a bag or case lined with soft pads so as
to prevent the coating on the camera body from
being worn.
After use, be sure to take the Cassette out and
detach the Battery from the Movie Camera or
pull out the AC Mains Lead from AC mains
socket.
≥If the Cassette is left in the Movie Camera, the
tape sags and deteriorates.
≥If the Battery is left on the Movie Camera for a long
time, the voltage drops excessively, and the
Battery will not function even after it is recharged.
ªAbout AC Adaptor
≥If the temperature of the Battery is extremely high
or extremely low, the [CHARGE] Lamp may
continue flashing, and the Battery may not be
charged. After the temperature of the Battery has
decreased or increased sufficiently, charging
starts automatically. If the [CHARGE] Lamp
continues to flash even after the Battery
temperature has decreased or increased
sufficiently, the Battery or AC Adaptor may be
faulty. In this case, please contact a dealer.
≥If the Battery is warm, charging takes a longer time
than normal.
≥If you use the AC Adaptor near a radio, radio
reception may be disturbed. Keep the AC Adaptor
1 metre or more away from radio.
≥When the AC Adaptor is in use, it may generate
whirring sounds. However, this is normal.
≥After use, be sure to pull out the AC Mains Lead
from the AC mains socket. (If they are left
connected, a minute amount of current is
consumed.)
≥Keep the electrodes of the AC Adaptor and Battery
always clean.
ªCondensation
If the Condensation Indication flashes after the
Movie Camera is turned on, condensation has
formed inside the Movie Camera. In this case, the
Movie Camera power is turned off automatically
after about 1 minute.
Follow the steps below:
1
Take out the Cassette.
≥None of the other functions operate.
Depending on the amount of condensation,
removing the Cassette may even become
difficult. If this happens, wait for
2 to 3 hours before taking the Cassette out.
2
Open the Cassette Compartment Cover
and wait for 2 to 3 hours.
≥The number of hours to wait depends on the
amount of condensation and ambient
temperature.
3
2 to 3 hours later, turn on the Movie
Camera power and check to see if the
Condensation Indication is displayed.
≥Even if the Condensation Indication is not
displayed, as a precaution, please wait for
another hour before using the Movie Camera.