Filter
Top Products
46
COPY INHIBITED:
Because the medium is protected
by a copy guard, images cannot be
recorded correctly.
CAN NOT CHANGE MODE:
The Mode of the Movie Camera can
not be changed in the PC
connection Mode.
DISCONNECT DV CABLE:
If the Movie Camera is in Photo
Title (CAMERA mode) and the DV
Interface Cable is connected,
“DISCONNECT DV CABLE”
appears. In this case, remove the
DV Interface Cable from the Movie
Camera.
DISCONNECT USB CABLE:
If you are attempting to record from
a Cassette by pressing the PHOTO
SHOT Button when the USB Cable
is connected, “DISCONNECT USB
CABLE” appears. In this case,
remove the USB Cable from the
Movie Camera.
PICTURE (Blink during 3 seconds):
When making DV connection at the
time of M-CARD mode.
WEBCAM (Blink during 3 seconds):
When making DV connection at the
time of Web Camera mode.
STORAGE (Blink during 3 seconds):
When making DV connection at the
time of USB Device Drive/SD Drive.
~~~~~~~~~~~~~~~
Notes and Hints
ªSelecting Remote Controller
Modes
When 2 Movie Cameras are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do not
match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS]
Sub-Menu to the desired Remote Controller
Mode. (l 14)
Setup on the Remote Controller:
[VCR1]: Press the [D] Button and [∫] Button
simultaneously.
[VCR2]: Press the [E] Button and [∫] Button
simultaneously.
≥When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
ªConcerning the Power Supply
≥When the Movie Camera is used for a long time,
the Camera body becomes warm, but this is not
a malfunction.
≥If the [CHARGE] Lamp does not light up
although the Battery is attached to AC Adaptor,
detach the Battery and reattach it.
≥Battery CGP-D110 and CGP-D105 cannot be
charged with this AC Adaptor.
ªInserting/Removing the Cassette
≥If a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
≥When inserting the cassette, make sure it faces
in the right direction and then push it in until it
stops.
ªAlarm Sounds
When [BEEP SOUND] on the [OTHER
FUNCTIONS] Sub-Menu on the [CAMERA
FUNCTIONS] Main-Menu is set to [ON],
confirmation/alarm beeps are issued as follows.
1 Beep
≥When you start recording.
≥When you switch the [VCR/OFF/CAMERA/
M-CARD] Switch from [OFF] to Camera Mode or
Card Recording Mode.
2 Beeps
≥When you pause recording.
4 Beeps
≥If you perform a wrong operation before or
during recording.
ªRecording
≥Before turning on the power, remove the Lens
Cap. If the Lens Cap is still attached when the
power is turned on, Automatic White Balance
Adjustment (l 56) may not function correctly.
ªRecording Check
≥For Recording Check, the recording speed mode
(SP/LP) must be the same as the mode used for
the recording. If different, playback images will
be distorted.
ªRecording with the Built-in Video
Light
≥The subject should be within 1.5 metres of the
Movie Camera.
≥Using the Video Light reduces battery time.
≥Set the Video Light to off when not in use.
≥Do not look directly into the light.
≥If the Video Light is used with a Conversion lens
attached, a slight vignetting (darkening around
edges) effect occurs on the screen.
EG-ENG.book 46 ページ ２００３年１月６日 月曜日 午後３時４３分