Filter
Top Products
55
Indications
1: The Time Code becomes inaccurate.
1: The Time Code Indication counter may not
be constant in the reverse direction in Slow
Motion Playback Mode, but this is not a
malfunction.
2: The Remaining Tape Time Indication
disappears.
2: When you record still pictures in Photoshot
Mode, the Remaining Tape Time Indication
may disappear temporarily. However, it
reappears when recording normally.
3: The Remaining Tape Time Indication does
not match the actual remaining tape time.
3-1: If scenes of less than 15 seconds are
continuously recorded, the remaining tape
time cannot be displayed correctly.
3-2: In some cases, the Remaining Tape Time
Indication may show remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
Playback (Images)
1: Images cannot be played back even when
the [1] Button is pressed.
1: Is the [VCR/OFF/CAMERA/M-CARD] Switch
set to [VCR]? If it is set to the other position,
the playback function cannot be used. (l 30)
2: Mosaic-pattern noise appears on images
during Cue, Review or Slow Motion
Playback.
2: This phenomenon is characteristic of digital
video systems. It is not a malfunction.
3: Although the Movie Camera is correctly
connected to a TV, playback images
cannot be seen.
3: Have you selected “Video Input” on the TV?
Please read the operating instructions of your
TV and select the channel that matches the
input sockets used for the connection.
4: Playback image is not clear.
4: Are the heads of the Movie Camera dirty? If
the heads are dirty, playback image cannot
be clear. (l 52)
Playback (Sound)
1: Sound is not played back from the built-in
speaker of the Movie Camera or the
headphones.
1: Is the volume too low? Push the [VOLUME]
Lever to adjust the volume. (l 30)
2: Different sounds are reproduced at the
same time.
2: [12bit AUDIO] on the
[PLAYBACK FUNCTIONS] Sub-Menu of the
[VCR FUNCTIONS] Main-Menu has been set
to [MIX]. As a result, the original sound and
sound that was recorded by audio dubbing
are played back together. It is possible to
reproduce the sounds separately. (l 35)
3: The original sound was erased when
audio dubbing was performed.
3: If you perform audio dubbing on a recording
done in [16bit] Mode, the original sound will
be erased. If you wish to preserve the original
sound, be sure to select [12bit] Mode at the
time of recording.
4: Sounds cannot be played back.
4-1: Although a Cassette with no audio dubbing is
being played, is [12bit AUDIO] on the
[PLAYBACK FUNCTIONS] Sub-Menu of the
[VCR FUNCTIONS] Main-Menu set to [ST2]?
To play back a Cassette with no audio
dubbing, [12bit AUDIO] must be set to [ST1].
(l 35)
4-2: Is the Variable Speed Search Function
working? Press the [1] Button to cancel the
Variable Speed Search Function. (l 31)
Card (NV-DS65 only)
1: Card Photoshot Playback images do not
look normal.
1: The picture may be damaged. In order to
prevent the loss of image data, backing up on
a personal computer is recommended.
(l 37, 49)
2: Even if a Card is formatted, it cannot be
used.
2: Either the Movie Camera or the Card may be
damaged. Please consult a dealer.
~~~~~~~~~~~~~~~
Explanation of Terms
ªDigital Video System
In a digital video system, images and sounds are
converted into digital signals and recorded on a
tape. This complete digital recording is capable of
recording and playback with minimal image and
sound deterioration.
In addition, it automatically records data, such as
Time Code and Date/Time, as digital signals.
Compatibility with S-VHS or VHS Cassettes
Because this Movie Camera employs a digital
system for recording image and sound data, it is
not compatible with conventional S-VHS or VHS
video equipment that employs an analog
recording system.
The size and shape of the Cassette are also
different.
EG-ENG.book 55 ページ ２００３年１月６日 月曜日 午後３時４３分