Filter
Top Products
38
LSQT1093
Setup
Inserting/removing an SD
card
Be sure to set the mode dial to OFF before
inserting/removing an SD card.
1 Set the mode dial to OFF.
≥Check that the status indicator has gone
off.
2 Open the LCD monitor and then
insert/remove the SD card into/
from the card slot.
≥When inserting an SD card, face the label
side A upwards and press it straight in as
far as it goes.
≥When removing the SD card, press the
center of the SD card and then pull it
straight out.
ª Concerning the SD card
≥Electrical noise, static electricity or failure of
this unit or the SD card may damage or erase
the data stored on the SD card. We
recommend saving important data on a
computer using the supplied USB cable
beforehand. (l 104)
ª Card access lamp
≥When this unit accesses the SD card (reading,
recording, playback, erasing, etc.), the access
lamp lights up.
≥If the following operations are performed when
the access lamp is lit, then the SD card or the
recorded data may be damaged or this unit
may malfunction.
– Removing the SD card
– Operating the mode dial
– Removing the battery or disconnecting the
AC adaptor
If the SD card is inserted or removed while the
power is on, this unit may malfunction or the
data recorded on the SD card may be lost.
A
LSQT1093ENG.book 38 ページ ２００７年１月１５日 月曜日 午前９時２３分