Filter
Top Products
Advanced
42
VQT0Y69
• The available flash range is an
approximation.
• Refer to P72 for the ISO sensitivity.
• Refer to P26 for the focus range.
• If ISO sensitivity is set to [AUTO] or
[ ] (DMC-FX07) when using the flash,
it will be automatically increased to a
maximum of [ISO400].
• To avoid noise, we recommend
decreasing the ISO sensitivity (P72) or
setting [PICT.ADJ.] to [NATURAL]. (P78)
• If you take a picture with the flash at close
range when the zoom is near [W] (1k),
the edges of the recorded picture may
become dark. Rotate the zoom lever
slightly and then take the picture.
∫ Shutter speed for each flash setting
¢5 The shutter speed changes depending
on the slow shutter setting. (P77)
• There may be differences in the above
shutter speeds in scene mode.
– [NIGHT SCENERY] (P51):
8 seconds to 1/2000th of a second
– [FIREWORKS] (P53):
1/4th of a second, 2 seconds
(DMC-FX07)/1 second (DMC-FX3)
– [STARRY SKY] (P54):
15 seconds, 30 seconds, 60 seconds
• Do not look directly at the flash at
close range when it is activated.
• If you bring the flash too close to an
object, the object may be distorted or
discolored by the heat or lighting from
the flash.
• Do not cover the photo flash with your
fingers or other objects.
• In economy mode, the LCD monitor
turns off and the status indicator lights
while the flash is charging. [This does
not happen when using the AC adaptor
(DMW-AC5; optional).] If the remaining
battery power is low, the length of time
that the LCD monitor turns off to
charge may become longer.
• If you press the shutter button halfway
when the flash is activated, the flash icon
turns red.
• When the jitter alert appears, we
recommend using a tripod.
• When you take a picture beyond the
available flash range, the exposure may
not be adjusted properly and the picture
may become bright or dark.
• When the flash is being charged, the flash
icon blinks red, and you cannot take a
picture even when you press the shutter
button fully.
• When taking a picture with the flash, the
white balance is automatically adjusted
(except for [ ]). However, the white
balance may not be properly adjusted if
the flash level is insufficient. (P70)
• When the shutter speed is fast, the flash
effect may not be sufficient.
• If you repeat taking a picture, it may not
actually be taken even if the flash is
activated. Take a picture after the access
indication disappears.
• The red-eye reduction effect differs
between people. Also, if the subject was
far away from the camera or was not
looking at the first flash, the effect may not
be evident.
• When you set burst mode or auto bracket,
only 1 picture is recorded for every flash
activated.
Flash setting
Shutter speed
(Sec.)
:AUTO
1/30 to 1/2000
:AUTO/
Red-eye
reduction
: Forced ON
: Forced ON/
Red-eye
reduction
: Slow sync./
Red-eye
reduction
1/8
¢5
to 1/2000
: Forced OFF
VQT0Y69ENG.book 42 ページ ２００６年６月３０日 金曜日 午前１１時７分