Filter
Top Products
Connecting to other equipment
93
VQT0Y69
∫ Conditions under which a different
folder number is used
In the following cases, the picture is not
recorded in the same folder as the
previously recorded picture. It is recorded
in a folder with a new number.
1 When the folder just recorded to contains
a picture file with the number 999 in it
(example: P1000999.JPG).
2 When the card just recorded to contains,
for example, a folder with the number
100 [100_PANA] in it and that card is
removed and replaced with a card that
has a folder with the number 100 in it
recorded by a camera from a different
maker (100XXXXX, with XXXXX being
the name of the maker) and then a
picture is recorded.
3 When recording after selecting
[NO.RESET] (P22) from the [SETUP]
menu. (Pictures will be recorded to a
new folder with a number sequential to
the folder recorded to immediately
before. By using [NO.RESET] on a card
that does not contain folders or pictures,
such as one just formatted, the folder
number can be reset to 100.)
∫ PictBridge (PTP) setting
Even if you set [USB MODE] to
[PictBridge (PTP)], you can connect to your
PC if the OS is “Windows XP” or “Mac OS
X”.
• Pictures can only be read on the camera.
They cannot be written to a card or
deleted.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
• Do not use any other USB connection
cables except the supplied one.
• Do not disconnect the USB connection
cable while [ACCESS] is displayed.
• When there are many pictures on the
card, it may take some time to transfer
them.
• You may not be able to play back motion
pictures on the card correctly when the
camera is connected to a PC. Import the
motion picture files to the PC and then
play them back.
• If battery power is exhausted while the
camera and the PC are communicating,
the recorded data may be damaged.
When you connect the camera to the PC,
use a battery with sufficient battery power
(P13) or the AC adaptor (DMW-AC5;
optional).
• If the remaining battery power becomes
low while the camera and the PC are
communicating, the status indicator blinks
and the alarm beeps. In this case, stop
the communication at once on the PC.
• When connecting the camera to a
“Windows 2000” OS PC with the USB
connection cable, do not replace the
card while the camera and the PC are
connected. The information on the card
may be damaged. Disconnect the USB
connection cable before replacing the
card.
• Pictures edited or rotated with a PC may
be displayed in black in playback mode
(P33), multi playback (P65) and calendar
playback (P66).
• For information about this, refer to the
separate operating instructions for PC
connection.
• Read the operating instructions for the
PC.
• If a card is not inserted when the camera
is connected to the PC, you can edit or
access the pictures on the built-in
memory. If a card is inserted, you can edit
or access the pictures on it. (DMC-FX3)
• You cannot switch between the built-in
memory and the card while the camera is
connected to the PC. When you want to
switch between the built-in memory and
the card, disconnect the USB connection
cable, insert (or remove) the card and
then connect the USB connection cable to
the PC again. (DMC-FX3)
VQT0Y69ENG.book 93 ページ ２００６年６月３０日 金曜日 午前１１時７分