Filter
Top Products
37
LSQT1040
Recording
Recording motion pictures
A Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0h00m]
flashes red.)
B Recording mode
C Recording time elap sed
≥ While motion picture recording is in progress, do not
disconnect the battery or AC adaptor. If you do, a
repair disc message may be displayed when the
power is turned back on. (l 83, About recovery)
Press the MENU button, then select [ BASIC] #
[RECMODE] # desired item and press the joystick.
This unit records in VBR. VBR is an abbreviation for Variable Bit Rate. VBR recording automatically
varies the bit rate (amount of data in a fixed time) depending on the subject being recorded. This
means if a subject with sharp movements is recorded, the recording time is reduced.
≥ Mosaic-pattern noise may appear on a playback
image in the following cases.
– When there is a complicated pattern in the
background
– When the unit is moved too much or too fast
– When a subject with sharp movements has been
recorded
(Particularly if [ REC MODE] was set to [ ]
during recording.)
Screen indications in the disc recording mode
R 0h02m
R 0h02m
R 0h02m
0h00m10s
0h00m10s
0h00m10s
SP
A
B
C
Immediately after recording finishes the ACCESS/PC lamp lights. While it lights, the disc is
rotating and disc information is being recorded. If you run while holding the unit or swing it, the
recorded images may be distorted so do not strongly shake or cause impact to it.
Changing the recording mode of the motion picture
Recording modes and recordable time available for the motion picture
Recording mode
Recordable time
(on single side )
XP
(High quality) Approx. 18 min Image quality prioritized
SP
(Normal) Approx. 37 min
LP
(Long play) Approx. 75 min Recording time prioritized
LP
D105(P)eng.book 37 ページ ２００６年１月１６日 月曜日 午後４時１分