Filter
Top Products
11.2 Configure the settings relating to JPEG images
[JPEG/H.264]
Click the [JPEG/H.264] tab on the “Image/Audio” page. (®page 51, page 53)
IMPORTANT
• When “VGA Quad streams [4:3]” is selected for “Image capture mode”, JPEG images cannot be set.
JPEG
Configure the settings such as “Refresh interval (JPEG)*”, “Image capture size” and “Image quality setting” on
this section. Refer to page 90 for further information about the settings relating to H.264 images.
"Live" page (Initial display)
Configure the settings relating to the JPEG images displayed on the “Live” page.
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image from the following.
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*
• Default: 5fps
Note
• When “On” is selected for “H.264 transmission”, the refresh interval may be longer than the set value
when any value with an asterisk (*) on the right is selected.
• Depending on factors such as the network environment, the resolution, the image quality, or the number
of computers concurrently accessing the camera, the transmission interval may be longer than the set
value.
• If images are not delivered in the specified transmission interval, you can make the images be delivered
closer to the specified time by lowering the resolution or image quality.
[Image capture size]
When JPEG images are displayed on the “Live” page, select the resolution for the image to be initially displayed.
The following is a list of “Image capture size” settings that can be selected depending on “Image capture
mode”.
Operating Instructions 87
11 Configure the settings relating to images and audio [Image/Audio]