Filter
Top Products
When “VGA Quad streams [4:3]” is selected for “Image capture mode”, unicast port numbers can be set for
each image (“Ch1” - “Ch4”).
• Available port number: 1024 - 50000 (Only even numbers are available.)
• Default:
– H.264(1): 32004
– H.264(2): 32014
[Unicast port2(Audio)]
*2
Enter the unicast port number (used to transmit audio from the camera).
When “VGA Quad streams [4:3]” is selected for “Image capture mode”, unicast port numbers for audio can
only be set to “Ch1”.
• Available port number: 1024 - 50000 (Only even numbers are available.)
• Default:
– H.264(1): 33004
– H.264(2): 33014
[Multicast address]
*3
Enter the multicast IP address. Images and audio will be transmitted to the designated IP address.
When “VGA Quad streams [4:3]” is selected for “Image capture mode”, multicast IP addresses can be set for
each image (“Ch1” - “Ch4”).
• Available IPv4 address: 224.0.0.0 - 239.255.255.255
• Available IPv6 address: Multicast address starting with “FF”
• Default:
– H.264(1): 239.192.0.20
– H.264(2): 239.192.0.21
Note
• Enter a multicast IP address after checking available multicast address.
[Multicast port]
*3
Enter the multicast port number (used to transmit images from the camera).
When “VGA Quad streams [4:3]” is selected for “Image capture mode”, multicast port numbers can be set for
each image (“Ch1” - “Ch4”).
• Available port number: 1024 - 50000 (Only even numbers are available.)
• Default: 37004
Note
• When audio is transmitted from the unit, the port number to be used will be the multicast port number
plus “1000”.
[Multicast TTL/HOPLimit]
*3
Enter a value for “Multicast TTL/HOPLimit”.
• Available value: 1-254
• Default: 16
IMPORTANT
• When transmitting an H.264 image via a network, the transmitted image sometimes may not be
displayed depending on the settings of a proxy server or a firewall. In this case, refer to the network
administrator.
• When two or more network interface cards are installed on the PC in use, the network interface card(s)
not used for receiving images should be invalidated when displaying images using the multicast port.
96 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]