Panasonic WV-SW458E Security Camera User Manual


  Open as PDF
of 44
 
27
IMPORTANT:
•InputandoutputoftheExternalI/Oterminal2and3canbeswitchedbyconfiguringthe
setting. “Off” is selected by default. It is possible to determine whether or not to receive
input from External I/O terminal 2 and 3 (ALARM IN2, 3) by selecting “Off”, “Alarm input”,
“Alarm output” or “AUX output” for “Terminal 2” or “Terminal 3” on the [Alarm] tab of the
“Alarm” page. Refer to the Operating Instructions on the provided CD-ROM for further
information.
•WhenusingtheExternalI/Oterminalsastheoutputterminals,ensuretheydonotcause
signal collision with external signals.
•InorderfortheExternalI/Oterminaltodetect alarminputswhentheterminalstatusis
changed from Open to Close (On) or from Close to Open (Off), about 100 ms or more is
needed. Because alarms cannot be detected for about 5 seconds after a detection is
made, alarm inputs received within about 5 seconds after an alarm is detected are not
detected.
v Connect a LAN cable (category 5 or better, straight, STP*) to the network connector.
* E model only
b Connect the power cable.
IMPORTANT:
•The12VDCpowersupplyshallbeinsulatedfromthecommercialACpower.
• Whenusing12VDCpowersupply*
1
Connect the output cable of the AC adaptor to the 2P power cable (accessory).
• WhenusingPoE(IEEE802.3afcompliant)
Connect a LAN cable (category 5 or better, straight, STP*
2
) between a PoE device (such as
a hub) and the network connector of the camera.
*1 ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY or LIMITED POWER SOURCE.
*2 E model only
IMPORTANT:
•Useall4pairs(8pins)oftheLANcable.
•Themaximumcablelengthis100m{328feet}.
•MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.
•Whenconnectingboththe12VDCpowersupplyandthePoEdeviceforpowersupply,
12 V DC will be used for power supply. Depending on the PoE device used, the power
supply lamp may not light and the network connections may not be possible. In this case,
disable the PoE device setting, and refer to the operating instructions of the PoE device in
use.
•WhentheLANcableisdisconnectedonce,reconnectthecableafterabout2seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE
device.
 previous next