Pelco 35X Security Camera User Manual


 
44 C3463M (10/09)
ALARMS
The 23X models have one alarm input available. The 27X and 35X models have seven alarm inputs. Alarm inputs can be configured as high,
medium, or low priority. When an alarm is received, an input signal to the dome triggers the user-defined action (go to preset, run pattern, etc.)
configured for the alarm.
Note: Refer to the notation in step 6 for the limited alarm features available for 23X models.
There are three global alarm settings:
RESUME: This mode lets the dome resume its previous activity (scan, pattern, or previous position) after all alarms are cleared.
SEQUENCE: This is the time the dome will perform an alarm activity when more than one alarm of the same priority occurs at the same time.
RESET DELAY: This is the amount of time the dome considers the alarm to be active after it has physically cleared.
Use the following steps to configure the alarm settings.
1. Use the joystick to position the cursor beside ALARM SETTINGS. Press Iris Open.
2. Select the alarm number:
a. Use the joystick to position the cursor beside ALARM NUMBER.
b. Press Iris Open. The cursor moves to the right.
c. Move the joystick up or down to view selections. Press Iris Open to enter selection.
3. Select the alarm priority:
a. Use the joystick to position the cursor beside ALARM PRIORITY.
b. Press Iris Open. The cursor moves to the right.
c. Move the joystick up or down to view the available selections. Available settings include HIGH, MEDIUM, and LOW (default). If
multiple alarms with different priorities are active at the same time, the dome will only go to the alarms with the highest priority.
d. Press Iris Open to enter selection.
HIGH: Alarm action takes highest priority and will override manual PTZ control.
MEDIUM/LOW: Alarm action will not occur if an alarm occurs during manual pan, tilt, and zoom control.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
DOME SETTINGS
BACK
EXIT
RESUME
SEQUENCE (SECS)
RESET DELAY (SECS)
<ALARM SETTINGS>
ALARMS
BACK
EXIT
ALARM SETTINGS
ALARM NUMBER
ALARM PRIORITY
ALARM ACTION
ACTIVATE AUX
ALARM CONTACT
<EDIT SCHEDULE>
*This setting applies only to Pressurized Spectra IV dome systems.