Filter
Top Products
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA •
www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Pelco and the Pelco logo are registered trademarks of Pelco. ©Copyright 2005, Pelco. All rights reserved.
Spectra III and Endura are trademarks of Pelco.
Label Position
The Title Text label can be positioned anywhere on the monitor. This feature
allows you to customize the appearance of your monitor screen.
To move the Title Text label, do the following:
1. Use the joystick to position the cursor beside a label.
2. Press Iris Open.
3. Use the joystick to move the label up, down, left, and/or right.
4. Press Iris Open.
5. Repeat steps 1 through 4 to position other labels.
6. Position the cursor next to Save and Exit. Press Iris Open to save the settings and exit the menu.
Spectra III EVS
If your dome drive is used in a Spectra III EVS Series (Endura
™
) dome system, the following instructions tell you how to access the main programming menu
from an Endura WS5050 Workstation or VCD5000 video console display.
To access the main programming menu from a WS5050:
1. Right-click in the video pane of the Spectra dome system.
2. Click Preset and then click Select Preset.
3. Enter 95 and then click OK.
To access the main programming menu from a VCD5000:
1. Enter 95 for the preset action. The shortcuts menu appears.
2. Press the Preset button on the KBD5000.
BACK
EXIT
PRESET LABEL 2 (SECS)
ZONE LABEL 2 (SECS)
ZOOM 2 (SECS)
AZIMUTH/ELEVATION 2 (SECS)
DIRECTION OFF
ALARM MESSAGE 2 (SECS)
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
[ZONE LABEL-------]
[PRESET LABEL-------]
[ALARM 1-------]
[ALERT MESSAGE-------]
[TITLE TEXT-------]
SAVE AND EXIT
CANCEL AND EXIT
HELP
XXX
o/-XXXo
NE
XXX.XX
LABEL POSITION