Filter
Top Products
C2487M-A (4/05) 35
NOTE: Increase the size of
the window if any part of the
blanked area is revealed
during pan, tilt, and zoom
operations.
6. The blanked area can be programmed to turn on or off at a specified zoom point. To
set the zoom point:
a. Use the joystick to position the cursor beside EDIT WINDOW ZOOM, and then
press Iris Open.
b. Zoom in to the point where you want window blanking to turn on. Press Iris
Open to set the zoom point.
NOTE: Since the area is already blanked out, it may be difficult to determine when you
want window blanking to turn on. Reverse the window before setting the zoom point.
When finished reverse the window again to blank out the area.
(See page 9)
Quick Programming Guide
Window Blanking Disabled Window Blanking Enabled